Seed coating

Seeds are coated for several reasons, such as improvement of the bulk properties, as well as provision of fertilizers, protective agents etc. within the coating. Tylose® based coatings are very stable and enable the crop to recieve the active substances reliably and at the right time.

 

Low viscosity Tylose® grades are recommended for this application.

Tylose Grades
 
Fact Sheet
H 10 YG4
MH 50 G4
MOBS 50 G4

Further applications

Further applications

Tylose® has numerous advantageous properties such as thickening, water retention, adhesion, binding, plasticising, film forming, gelling and surface tension modifying. Utilising these properties makes Tylose® a highly suitable additive for many applications.

» More information

Nomenclature Information

M
H
O
A
X



B
F
S
T
Type of ether
Methyl
Hydroxyethyl
Hydroxypropyl
Allyl
Hydrophobe
etherification

Degree of
etherification
Special higher
degrees of
etherification,
depending on the
individual type of
ether

60000
30000
15000
10000
6000
4000
2000
1000
300
200
.
.
.
01
02
03
04
.
.
.
Viscosity level
The viscosity level
is based on
Hoeppler: 2%
solution of the
commercial product
with 5% moisture
content, 20ºC,
20º dH
(German hardness)








Consistency
increasing
modification
The least one of
the two last
digits is a
number > 0

Y
K
N




G4
G6
G8

P2
P3
P4
P6
Chemical refinement
Delayed solubility products
Readily soluble granules
non-delayed solubility products
(only for Tylose H grades) *

Degree of particle size
Types of granules:
Granules (< 500 μm)
Granules (< 400 μm)
Granules (< 300 μm)
Powder types:
Powder (< 180 μm)
Fine Powder (< 125 μm)
Fine powder (< 125 μm)
Ultra fine powder (< 100 μm)
* Tylose MH and MO Grades are not explicitly marked by ”N”, even if these products are ”non-delayed solubility products”.
TabTop