EIFS (Exterior Insulation Finishing System)

For ecologic as well as economic reasons it makes sense to thermally insulate buildings. Most effective is exterior insulation, which is used in new buildings but also during renovation of existing buildings. Insulation boards are normally made of expanded polystyrene (EPS), glass wool or mineral wool.

 

Tylose® MC improves the workability and increases both adhesion and embedding of the net. In addition to the cement binder, emulsion powders must be added to ensure sufficient adhesion to the insulation board.

Tylose Grades
Product Characteristic  
Fact Sheet
MB 15009 P2
Final consistency : moderate
MH 10007 P4
Final consistency : moderate
MHS 30027 P6
Final consistency : moderate

Building materials

Building materials

Tylose® is an essential component in many building materials. It is mainly responsible for water retention, consistency and adhesion. The homogeneity, stability and workability of mortars are improved by the use of Tylose®. Using Tylose® enables the manufacturing of modern and efficient construction materials, such as machine plasters and thin bed adhesives.

» More information

Nomenclature Information

M
H
O
A
X



B
F
S
T
Type of ether
Methyl
Hydroxyethyl
Hydroxypropyl
Allyl
Hydrophobe
etherification

Degree of
etherification
Special higher
degrees of
etherification,
depending on the
individual type of
ether

60000
30000
15000
10000
6000
4000
2000
1000
300
200
.
.
.
01
02
03
04
.
.
.
Viscosity level
The viscosity level
is based on
Hoeppler: 2%
solution of the
commercial product
with 5% moisture
content, 20ºC,
20º dH
(German hardness)








Consistency
increasing
modification
The least one of
the two last
digits is a
number > 0

Y
K
N




G4
G6
G8

P2
P3
P4
P6
Chemical refinement
Delayed solubility products
Readily soluble granules
non-delayed solubility products
(only for Tylose H grades) *

Degree of particle size
Types of granules:
Granules (< 500 μm)
Granules (< 400 μm)
Granules (< 300 μm)
Powder types:
Powder (< 180 μm)
Fine Powder (< 125 μm)
Fine powder (< 125 μm)
Ultra fine powder (< 100 μm)
* Tylose MH and MO Grades are not explicitly marked by ”N”, even if these products are ”non-delayed solubility products”.
TabTop