Hair conditioner

Human hair is stressed by combing, styling, oxidising products and environmental influences. The multitude of existing hair care and styling products reduce the appearance of this damage and at the same time, achieve the effects desired by the consumer. The use of a hair conditioner after shampooing makes the hair easier to comb and increases the bounce of the hair.

 

Medium to high viscosity Tylose® H types are recommended, which give the product the desired consistency and provide good stability, especially for products with pearlescent effects. Furthermore Tylose® types act as a film former and thus support the active ingredients by improving their adhesion to the hair. This is one of the key areas of use for Tylose® grades.

Tylose Grades
Product Characteristic  
Fact Sheet
H 100000 YP2
Thickening : very high
H 100070 NP2
Thickening : very high
H 30000 YP2
Thickening : high

Personal and home care

Personal and Home Care

In Personal and Home Care formulations the most important properties of Tylose® are thickening effect, respectively consistency regulation, stabilisation and high compatibility

with other ingredients such as surfactants.

» More information

Nomenclature Information

M
H
O
A
X



B
F
S
T
Type of ether
Methyl
Hydroxyethyl
Hydroxypropyl
Allyl
Hydrophobe
etherification

Degree of
etherification
Special higher
degrees of
etherification,
depending on the
individual type of
ether

60000
30000
15000
10000
6000
4000
2000
1000
300
200
.
.
.
01
02
03
04
.
.
.
Viscosity level
The viscosity level
is based on
Hoeppler: 2%
solution of the
commercial product
with 5% moisture
content, 20ºC,
20º dH
(German hardness)








Consistency
increasing
modification
The least one of
the two last
digits is a
number > 0

Y
K
N




G4
G6
G8

P2
P3
P4
P6
Chemical refinement
Delayed solubility products
Readily soluble granules
non-delayed solubility products
(only for Tylose H grades) *

Degree of particle size
Types of granules:
Granules (< 500 μm)
Granules (< 400 μm)
Granules (< 300 μm)
Powder types:
Powder (< 180 μm)
Fine Powder (< 125 μm)
Fine powder (< 125 μm)
Ultra fine powder (< 100 μm)
* Tylose MH and MO Grades are not explicitly marked by ”N”, even if these products are ”non-delayed solubility products”.
TabTop